Print neat calibration sheet8/27/2023 ![]() It can determine if the carbon rods need cleaning based on either the current draw or maybe missed steps if it has that capability. There may be a few what look like random moves when it is checking the head for ease of movement. Then there’s the nozzle wipe at the wiper near the chute after a purge plus the nozzle wipe on the build plate itself just before the leveling procedure. It will skip this step with the textured plate. This will compensate for any damage or glue build up that may exist. It will also scan the intended print area before beginning a print if you have a plate that is not textured installed, probably so that it can build a map to compare with when doing the first layer check. There are the 36 bed leveling points across the build sheet. At the front edge of the build sheet is the QR code for which type of sheet it is. On the right half way back is the calibration area for the lidar and camera built into the print head. The right front corner is the home position, it will drive the print head into the corner in both the X and Y directions when setting home, and may do both twice to dial the home position in. It may always do a cut move before purging as it may not know if there is filament in the path. Viewed from the front, the left front corner is where the cutter is located. I don’t know all of the reasons but do know the purpose of some locations.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |